Home » Teaching & Academics » Introduction to Testing of VLSI Circuits & Fault Modeling

[Free] Introduction To Testing Of Vlsi Circuits &Amp; Fault Modeling

Introduction to Testing of VLSI Circuits & Fault Modeling Using DSCH 3.5 – Free Course

Added on May 29, 2023 Teaching & Academics 2 min read

What you’ll learn

• Introduction to Testing, Principle of Testing, Empirical Rule
• Levels of Fault Modeling, Stuck at Faults
• Introduction to Simulation and DSCH 3.5 Software
• Conversion of DSCH file to Microwind file
• Implementation of AND gate and its fault analysis in DSCH 3.5 software
• Implementation of Half Adder and Full Adder and their fault analysis in DSCH 3.5 software

Requirements

• Basic Concepts of VLSI ,Knowledge of Logic Gates

Description

This course will not only give you theoretical understanding of Testing concepts but I am sure it will improve your confidence in designing and Fault Modeling analysis of VLSI Circuits.

This course will definitely boost your interest in VLSI Domain.

You will learn following concepts on this course

Introduction to Testing, Difference between testing and verification , Principle of Testing, Benefits of Testing , Types of Testing , Empirical Rule.

Concepts of Defect, Fault and Error, Levels of Fault Modeling, Types of faults, How we can calculate Single Stuck at Faults and Multiple Stuck At Faults of different circuit.

Introduction to Simulation and DSCH 3.5 Software.

Conversion of DSCH file to Microwind file.

Implementation of AND gate and its fault analysis in DSCH 3.5 software.

Implementation of Half Adder and Full Adder and their fault analysis in DSCH 3.5 software.

After completing this course you will be able to design and simulate circuits and also will able to do fault analysis.

We are going to use DSCH 3.5 and Microwind Software for implementing circuits.

After completing this course you will be able to design and simulate circuits and also will able to do fault analysis.

I wish you all the best for course.