
[100% Off] Stm32 Embedded Systems With Mbed Ce: Real Hardware Online
Program a real STM32 from your browser: GPIO, ADC, PWM, servos and a smart parking project with LabsLand and Mbed CE
What you’ll learn
- Compile and run Mbed CE C++ programs on a real STM32 through the LabsLand browser IDE.
- Read active-low buttons and control LEDs using the lab pin table and the DigitalIn and DigitalOut APIs.
- Use serial messages and ADC readings to debug and test a voltage warning controller.
- Control RGB brightness and servo position with appropriate PWM periods and pulse widths.
- Combine sensor logic, timing and manual overrides in a smart parking controller, then document its behavior.
- Explain a basic IoT device–gateway–cloud architecture and identify the firmware, protocol and peer needed for a wireless link.
- Record predictions, real observations and test results to explain embedded program behavior.
Requirements
- Familiarity with basic programming concepts: variables, conditions and loops.
- A modern browser and reliable internet connection; no personally owned STM32 board is required.
- A free LabsLand account. The course includes one week of STM32 Nucleo (Mbed) access, activated separately using the course guide.
- No previous STM32 or embedded systems experience is required.
Description
This course contains the use of artificial intelligence.
Learn how an embedded program connects inputs, decisions and real outputs. You will write C++ with Mbed OS Community Edition, compile it in the LabsLand browser IDE, and run the resulting firmware on a remotely accessible NUCLEO-WB55RG board. No local toolchain or personally owned development board is required.
Start with a small LED program and learn to distinguish saving, compiling, programming and observing. Then build interactive projects using digital inputs and outputs, serial messages, analog measurements, hardware PWM and a positional servo. Five assignments and eight knowledge checks help you turn each concept into a program you can explain and test. The final smart parking challenge combines real microcontroller execution and GPIO with a virtual parking environment.
The lessons use narrated animations, readable code walkthroughs, signal diagrams and genuine captures from the remote lab. An illustrated presenter appears briefly to introduce ideas and questions. Downloadable source, transcripts and test checklists let you work at your own pace.
You should already understand basic variables, conditions and loops. This is an introduction to embedded development, rather than a complete programming course from zero. The wireless section teaches devices, gateways and IoT architecture; the practical assignments use the prepared wired peripherals and do not include setting up a Bluetooth or internet connection from the board.
Hands-on access: the course includes one free week of LabsLand STM32 Nucleo (Mbed) access. Activate it separately with the link in the access guide when you are ready for the practical assignments. The week starts when you activate it, rather than when you enroll in Udemy. Optional one-, three- and six-month lab licences are available if you want more practice. The guide explains activation, expiry and returning to the lab.
Author(s): Luis Rodríguez Gil, Pablo Orduña








